draftsperson.net http://draftsperson.net/forum/index.php Re: New here and Asking Advice on Resume http://draftsperson.net/forum/index.php?topic=68389.msg72691#msg72691 General Discussion http://draftsperson.net/forum/index.php?action=post;topic=68389.0 Tue, 19 Nov 2019 02:40:18 GMT http://draftsperson.net/forum/index.php?topic=68389.msg72691#msg72691 Re: Typical Countersinking Details http://draftsperson.net/forum/index.php?topic=111.msg72690#msg72690 Is drawing the edges at 45 degrees the norm? General Discussion http://draftsperson.net/forum/index.php?action=post;topic=111.0 Mon, 30 Sep 2019 15:13:45 GMT http://draftsperson.net/forum/index.php?topic=111.msg72690#msg72690 New here and Asking Advice on Resume http://draftsperson.net/forum/index.php?topic=68389.msg72689#msg72689 I've been a mech drafter for the past 22 years and have done everything from HVAC design layouts, to Cfan/axial fan/sheet metal manufacturing to process piping, Inventor modelling for astronomical telescope and urainium mining water...]]> General Discussion http://draftsperson.net/forum/index.php?action=post;topic=68389.0 Mon, 30 Sep 2019 14:20:03 GMT http://draftsperson.net/forum/index.php?topic=68389.msg72689#msg72689 Re: Recognizing parts in a manual drafting set. http://draftsperson.net/forum/index.php?topic=78.msg72688#msg72688 The ribbed cylinder us a pen handle, used for holding a variable width nib for dipping in an inkwell The slots allow for a tight interference fit. The washer looking object I am unsure of. Perhaps a spacer from around a compass extension piece: guessin... General Discussion http://draftsperson.net/forum/index.php?action=post;topic=78.0 Tue, 24 Sep 2019 03:18:49 GMT http://draftsperson.net/forum/index.php?topic=78.msg72688#msg72688 Re: Typical Countersinking Details http://draftsperson.net/forum/index.php?topic=111.msg72687#msg72687 Usually I draw the edges at 45 degrees, flaring out at least 1/4 diameter = 1.5D, but actual installation depends on the shape of the underside of the fastener to be fitted, and the angle of the drill bits available General Discussion http://draftsperson.net/forum/index.php?action=post;topic=111.0 Tue, 24 Sep 2019 02:51:07 GMT http://draftsperson.net/forum/index.php?topic=111.msg72687#msg72687